Mikerosoft

I have searched on this topic extensively both on here and on honda-tech.
However, I have yet to find a definative answer for 5th gen coupes.
Every thread is answered by someone who has done it in their hatch and then the thread dies.
I am finally at the point where I am ready to order some new interior pieces.
I believe I need a combination of both Teg Coupe and Sedan rears to make it look/fit properly.
I am willing to purchase both if this will actually work properly.

What I know so far:
- Teg Coupe seats are not wide enough on the bottom.
- Teg Sedan fits on the bottom but to wide on the back.
What I don't understand, is how I could use a coupe back when it as a 50/50 split and my original seat is one piece.
I think this is where the coupe/hatch differs.

Has anyone successfully completed a rear seat swap with teg seats into a 5th gen coupe?
Possible to get some pictures? Or at least some advice?
I would really appreciate any help anyone can send my way.
Thank you in advance.

raiden571

hmm. i was under the impression that any 94 and up teg seats bolt up fine in the rear and look fine. not sure about from a four door. i suppose u could go to a junkyard and measure the seats.