Okay,
I need to get this straight,

I have 00 integra 2 door leather interior, door panels, front seats and rear seats on the way.

Will all of these swap into my 96 civic coupe with out any problems?


I read on another site that it said only the sedan integra rears will fit the civic coupe rear.

I would like to know before I get started.

 

Yeah, I wanted to get this straightened out too. But I believe someone told me that 2 door --> 2 door and sedan into four door civic. And you have to use the rails from the acura too. But I also asked because I wanted to know 100%

 

still waiting for an answer but my interior is on the way so I will post and let you know b/c my full interior is on the way.

i measured the sedan back seat of a teg b/c i just sold one and if I remember right the measurements in the sedan were longer than a civic so I don't think they can fit.

However, I also have in my possession the back seats out of an si in dark grey which should fit the 96 civic incase the tegs don't

Either way I will be selling one of them if your interested after I do the swap.

I am also completing my 96 civic into an 99-00 si body conversion which should look sweet

 

I think Nelson had ITR interior in his old civic.... PM him

 

ok here is the break down:

the 3g FRONT integra seats from the 94-01 2door will fit ur car but u have to swap ur 6g civic seat rails over to make it fit in like oem utiliziing all 4 mountin holes, otherwise boltin in the stock integra seat, u will net only 3 of the 4 mountin holes and thats retarded and unsafe.

the 3g REAR integra seats from the 94-01 2door is a 50/50 partition back and the seat cushion has a middle tray. ur 6g civic coupe back is a 60/40 partition and the seat cushion is all cushion. the seat bottom of the teg seat will fit but the back will not have the hinge to lock the seat in place as it is made for a 50/50 split with locks on both side.

the only way to get the back to look nice is to get the 3g REAR integra 94-01 4door back because it is a 100% 1 piece back so it will bolt into ur 6g civic coupe no prob.

the door panels will not fit unless modifications are made to the panel and ur door because the door handle and other misc stuff is in different locations and the dash and the door panel will not line up and modification to the door panel again has to be made, too much work for not much of a difference.

and the 3g integra seats whether it is leather or cloth, my guide works on both as the fabric is the only diff and doesnt interfear with the mechanical aspect. have fun.

 

96-2000 coupes and 4 doors had a 60/40 split, while the hatch had a 50/50 split

 

ur absoutely right. i just went and look at my 00si. i was thinkin about the 5g coupe because those had the 100% 1 piece back and the fact that i used to own one. thanks for the correction.