Washer Fluid Problem
Having trouble getting my wiper fluid to work. I checked all the fuses. They are all fine. I ran an air hose through the fluid tubes to see if anything was clogging it and it was fine no clogs. When I try to turn the wiper fluid on I can hear the motor but it just wont squirt any fluid out. Any suggestions as to what I else I can check? Any help would be great thanks.
|
Now did you try turning them on being disconnected from the squirters?
|
captain obvious says, "always check your actual tank for fluid" the pumps aren't hooked up at the bottom so if the fluid is below that point, you get no fluid!!!!
also check to see if your hose has a leak, or your squirters are clogged :thumbup: |
Your pump may have lost it's "prime" too. Run some fluid through the pump manualy to make sure there is liquid in the pump.
|
I'm having similar issues with my washer fluid system. I checked the fuse in the set under the steering wheel - it's one fuse for the wiper blade motor and the fluid motor, and the blades work.
I used a 12v battery to power the washer fluid motor and it squirted the blue stuff with no problems. Multimeter shows no voltage and resistance of 1 at the wiring harness that connects to motor when the system is activated. Are there any other fuses / relays i'm not aware of. Could this be the switch in the steering column, or does the wiper blade control module have anything to do with the fluid motor? I'm not looking forward to jacking around with all the wiring and a multimeter if it comes to that... |
All times are GMT -8. The time now is 09:02 AM. |
© 2024 MH Sub I, LLC dba Internet Brands