license holder on a 03 coupe
#1
03.Accord.Coupe.LX
Thread Starter
Join Date: May 2003
Location: Los Angeles, CA
Posts: 119
Likes: 0
Received 0 Likes
on
0 Posts
license holder on a 03 coupe
I got a 03 accord coupe lx. I just removed the whole license holder from the front bumper. Damn! there is a drilled hole on the bumper. I'm not sure if it's done by the manufacturer or the dealer.
#2
03 Accord Owner
Join Date: Jan 2003
Location: State College, PA
Posts: 111
Likes: 0
Received 0 Likes
on
0 Posts
It's done by the dealer - I bough t my car in Jersey - but I live in PA where they don't require front plates - so mine had to go, of course - and boom - there's a hole staring me in the face. It sux - but I'll live with it. I'm actually planning on mounting a remote radar detector sensor there now a-la by Valantine One
#3
03 Accord Owner
Join Date: Jan 2003
Location: State College, PA
Posts: 111
Likes: 0
Received 0 Likes
on
0 Posts
#4
Registered User
Join Date: Jun 2003
Location: SoCal 310
Posts: 66
Likes: 0
Received 0 Likes
on
0 Posts
I just bought a new 03 Coupe in California where front plates are required. Since the plates aren't here yet, I took the front plate holder off. There are no holes in my front bumper. The plate holder is attached to the bumper by two screws which are on the upper portion of the cutout in the bumper. I wish I had a digital camera so I could post a picture of it.
#5
mine has a hole
what i did was get a small thin eraser from one a mechanical pencil and cut it down to the diameter of the little hole. then, I stuffed the hole in with the rubber.
got some touch up paint and the hole is invisible
what i did was get a small thin eraser from one a mechanical pencil and cut it down to the diameter of the little hole. then, I stuffed the hole in with the rubber.
got some touch up paint and the hole is invisible
#6
03.Accord.Coupe.LX
Thread Starter
Join Date: May 2003
Location: Los Angeles, CA
Posts: 119
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by willba
mine has a hole
what i did was get a small thin eraser from one a mechanical pencil and cut it down to the diameter of the little hole. then, I stuffed the hole in with the rubber.
got some touch up paint and the hole is invisible
mine has a hole
what i did was get a small thin eraser from one a mechanical pencil and cut it down to the diameter of the little hole. then, I stuffed the hole in with the rubber.
got some touch up paint and the hole is invisible
#7
lots and lots of fail
Join Date: Dec 1999
Location: Deeeeeeeeeeeeeeetroit
Posts: 23,004
Likes: 0
Received 1 Like
on
1 Post
Originally posted by Fast_Draw
I'm actually planning on mounting a remote radar detector sensor there now a-la by Valantine One
I'm actually planning on mounting a remote radar detector sensor there now a-la by Valantine One