Wheel Well/Fender Mods?
#1
Junior Member
Thread Starter
Join Date: Apr 2003
Location: Jacksonville
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Wheel Well/Fender Mods?
Just wondering..
My car is lowered about 2.25" w/ 18s, and with my camber adjusted up front, I'm having an issue with my control arm sometimes catching on the small piece of metal that comes down from the top of the wheel well.
I was thinking about cutting/shaving it down a bit with a dremel, but I was wondering if anybody else had any issues with this.
Suggestions?
Thanks.
My car is lowered about 2.25" w/ 18s, and with my camber adjusted up front, I'm having an issue with my control arm sometimes catching on the small piece of metal that comes down from the top of the wheel well.
I was thinking about cutting/shaving it down a bit with a dremel, but I was wondering if anybody else had any issues with this.
Suggestions?
Thanks.
#2
1) raise your car using diff springs.
2) if its the arm catching the outter lip of the fender, see if you can roll the fender edge inward so it doesnt hang closer to the control arm. Ive seen articles online where a baseball bat can roll it. Roll along the tire or something.
2) if its the arm catching the outter lip of the fender, see if you can roll the fender edge inward so it doesnt hang closer to the control arm. Ive seen articles online where a baseball bat can roll it. Roll along the tire or something.