Honda Accord 90-93: Mugen Front Lip Install
03-05-2003, 07:42 PM
#1
Ownz JOO
Thread Starter
Join Date: Sep 2002
Location: Madison, Wisconsin
Posts: 268
Likes: 0
Received 0 Likes
on
0 Posts
4th Gen MUGEN FRONT LIP DIY!!!
Tools: Sockets, wrenches, philips screw driver, dremel with cutting bit, Haynes Manual, other things that i cant think of.
Step 1: Take bumper off
Step 2: Take bumper and lip to a nice place to work on with lighting and power outlets. I took mine into the basement.
Step 3: Cut off ALL tabs off the lip.
Step 4: Mount Lip on bumper by holding lip in place and using something to mark where to drill holes. While doing this, mark the edges so u can cut the excess length. Use a dremel or hax saw to cut it or anything else.
Here's a pic of the bending:
Step 5: After marking holes, take a drill with the proper size drill bit and drill the holes.
Step 6: Put lip back on the bumper and put the bolts, washers and nuts in place.
Step 7: Tighten all the bolts and make sure they're all in place.
Step 8: Put bumper back on. Be carefull not to drop the bumper. Finish product should look like this:
GOODLUCK!!!
Step 1: Take bumper off
Step 2: Take bumper and lip to a nice place to work on with lighting and power outlets. I took mine into the basement.
Step 3: Cut off ALL tabs off the lip.
Step 4: Mount Lip on bumper by holding lip in place and using something to mark where to drill holes. While doing this, mark the edges so u can cut the excess length. Use a dremel or hax saw to cut it or anything else.
Here's a pic of the bending:
Step 5: After marking holes, take a drill with the proper size drill bit and drill the holes.
Step 6: Put lip back on the bumper and put the bolts, washers and nuts in place.
Step 7: Tighten all the bolts and make sure they're all in place.
Step 8: Put bumper back on. Be carefull not to drop the bumper. Finish product should look like this:
GOODLUCK!!!
