How to check error codes for 92 Legend?
03-22-2003, 06:10 PM
#2
www.acura-legend.com
Join Date: May 2002
Location: Canton, Ohio
Posts: 90
Likes: 0
Received 0 Likes
on
0 Posts
A generic scan tool should be able to see what is causing the problem. You do have a check engine light on correct? That's the only way the scan tool will be able to tell there's a problem. Call the service department of your local Acura dealership and tell them what your problem is.
03-23-2003, 04:39 AM
#3
Senior Member
Join Date: Jun 2002
Location: Rockville Md
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
Shame on you Mike!
To check error codes you need to jumper the diagnostic connector on top of the ECU (under the passenger footwel carpet, the verticle portion). Turn the ignition on (don't start the car). The check engine light will blink long and/or short. Report back blinck counts here.
To check error codes you need to jumper the diagnostic connector on top of the ECU (under the passenger footwel carpet, the verticle portion). Turn the ignition on (don't start the car). The check engine light will blink long and/or short. Report back blinck counts here.
