1994 acura vigor factory car alarm
#1
Junior Member
Thread Starter
Join Date: Feb 2009
Location: St. louis, MO
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
1994 acura vigor factory car alarm
my 94 acura vigor factory car alarm wont shut off and i cant start up car is there anyway that i can disarm alarm
#2
Junior Member
Join Date: Aug 2008
Location: Minneapolis
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Alarm Disarm
Is there a fuse for it? Do you have the manual for the vehicle? If you disconnect the negative (black) battery cable for 20 minutes that should clear out the car's computer (make sure you have the radio code handy for restart if it's the factory radio)...just a few thoughts
#3
Junior Member
Join Date: Apr 2009
Location: Sacramento, CA
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
I just put the key back in. hmmm, doesn't happen to me unless, i went in from the other than driver side.. I'm getting a whole new upgraded alarm, so I'm not trippin on that.
Last edited by TranceVig; 04-15-2009 at 12:29 PM. Reason: more info
#5
Problem with the Vigor's factory alarm is that the electronic door lock actuator loses contact with the switch over time due to corrosion and will not send the signal to the alarm unit. The car will think that the door was not unlocked with the key, and will trigger the alarm to go off.
To remedy this, you can open the door from the passenger side like someone already mentioned, or fix the lock actuator. There's some great write-ups for this problem over at the Yahoo Groups site. You can find them over at acuravigorclub.com and read through some of the Timely Topics Articles, written by members of the Yahoo Group.
Hope that helps.
Shawn
To remedy this, you can open the door from the passenger side like someone already mentioned, or fix the lock actuator. There's some great write-ups for this problem over at the Yahoo Groups site. You can find them over at acuravigorclub.com and read through some of the Timely Topics Articles, written by members of the Yahoo Group.
Hope that helps.
Shawn
#6
Junior Member
Join Date: Aug 2009
Location: minneola kansas
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
wrong place
I just bought a 96 A when i push the alarm key it keeps unlocking and it will do that for a few sec does any1 know wat is wrong with it its the factory alarm
Last edited by luckyv; 08-09-2009 at 02:34 PM. Reason: wrong place