Where is the OBD data plug?
04-29-2008, 06:36 AM
#1
Junior Member
Thread Starter
Join Date: Apr 2008
Location: Ohio
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Where is the OBD data plug?
Ok I have a 95 Acura Integra and have looked just about everywhere for the OBD data plug but I can't find it or I'm over looking it. Can anyone help a girl out?
04-29-2008, 09:45 AM
#4
Apathy Kills
The OBD data connector in on the passenger side of the center console, about 3" above where the floor carpet rests on the raised section of the floor.
Feel along the back edge of the trim piece and you'll find it. There are no other plugs in the area and there are no panels to remove.
__________________
:: :ToDspin: - supermod - but who gives a shit?
:: HAN Integra FAQ: If, by some miracle, yours hasn't been stolen... check it out!
:: HAN Integra FAQ: If, by some miracle, yours hasn't been stolen... check it out!
04-30-2008, 12:48 PM
#6
Seni
Join Date: Aug 2003
Location: N.Y. Queens
Posts: 3,401
Likes: 0
Received 0 Likes
on
0 Posts
If you are just looking to get the CEL codes then its right under/behind your glove box on the passanger side. There are 2 plugs there. On has a 3 wire connector with 2 wires on it, thats your ABS plug. There is another 2 wire connector with 2 wires on it thats your CEL plug. They both should be blue.
That a paper clip to the CEL plug and jump the wires.
Long strokes are ten's
Short strokes are one's.
so Long,long,long,short,short = 32 so on and so forth. If you need more help Pm me.
That a paper clip to the CEL plug and jump the wires.
Long strokes are ten's
Short strokes are one's.
so Long,long,long,short,short = 32 so on and so forth. If you need more help Pm me.