New Person here....

[DetroitStyle]

Just got it today, and have just put in my DVD player so far. I have coil overs, and stock wheels that will be going on it at some point. Only plans for this are, a tune, cams, maybe boost, loose the black tail lights in favor of some stock ones, and do clear corners, maybe some "JDM" headlights. Here are some specs on it. Head: Stage 2 ported @ polished Ferrea Valves Stk size Exhaust/intake New OEM Retainers New Crower Valve Springs New OEM Valve seals New Valve retainers New OEM Camshaft seals Fully built Lower end F22b lower end: Block Hot tanked/ Main bearing journals all line honed Stk Bore JE 10:1 compression pistons Heat coated on side skirts and piston tops Shot peened rods out of H23a1 balanced Chromoly gap less rings Crankshaft polished/balanced OEM Rod Bearings OEM Main Bearings OEM Thrust washers OEM Timing Belt OEM Balance Shaft Belt OEM New head bolts OEM head gasket h23B1 OEM Oil Pump New OEM Knock Sensor New OEM Oil Pressure sensor New OEM Oil Orifice New OEM IAC Valve NEW OEM Balance shaft seal w/ retainer NEW OEM Crankshaft Seal NEW OEM intake manifold gasket New OEM Exhaust Manifold Gasket W/ 4-2-1 Header

Registered and logged-in users don't see this ad! Register your free account today.

[pow_pow]

Not likin' the tails, but the JDM headlights would look great. They really make a difference even though they don't seem like they would...

[DetroitStyle]

I found some DOT/SAE approved JDM knock offs that I like allot.

But yes, the tails and rims are going.

[JoePoonani]

Car looks like it's in pretty good shape minus the obvious blemishes.

[DarkStarr]

Looks nice, be sure to past some pictures after you are done cleaning it up.