LS/VTECH valve adjustment
12-30-2005, 04:33 PM
#1
Junior Member
Thread Starter
Join Date: Sep 2005
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
LS/VTECH valve adjustment
After replacing a blown head gasket, I'm getting to the part where I reinstall the cams and then need to adjust the valves. Did a little research and found that c-speed racing has got a fantastic how-to guide on this. Just one question, according to their website the specs are:
Factory spec for the B18C1/5 and B16A is:
Intake: 0.006"-0.007"
Exhaust: 0.007"-0.008"
Factory spec for the B18B and B20B/Z is:
Intake: 0.003"-0.005"
Exhaust: 0.006"-0.008"
I've got an LS/VTECH which is a B18C5 head on a B18B block. Which specs should I go with (exhaust overlaps), or should I just split the difference?
Factory spec for the B18C1/5 and B16A is:
Intake: 0.006"-0.007"
Exhaust: 0.007"-0.008"
Factory spec for the B18B and B20B/Z is:
Intake: 0.003"-0.005"
Exhaust: 0.006"-0.008"
I've got an LS/VTECH which is a B18C5 head on a B18B block. Which specs should I go with (exhaust overlaps), or should I just split the difference?
