extensioncordy

ok i dont want to look stupid...but i got a double bend shifter...which way does it bend towards? does it bend towards the driver or up more...i dont want to sound stupid but...i dont know! lol thanks ahead of time




I SEARCHED...and all the one i find on ebay or sites dont show them mounted in a car

CaliDELSOL93si

double bend is so the shifter is "closer to the driver", the bend should bend back toward the driver and rear of the car.

extensioncordy

thanks...now im going to use this girls lift....lol yea a 16 year old girl has a lift...dsm'er

CaliDELSOL93si

make sure you loob it up real good !!!!

extensioncordy

yea so i was taking out the old shifter...disconected the linkage then went to take off the plate holding the shifter in...turn the bolt and the top of the bolt is turning..its a round head so no sockets fit..also vise grips and plyer's are to big to fit into the hole from inside the cabin..

jdmeg6hatchy

i used vise grips, the top of the part shold have a square shape under the haed, push this down into the plate, it will hold it, or use vise grips. its a lil pain, but worth it. what kind of double bend did you get??

CaliDELSOL93si

skunk2 is the only way to go, hope you got one of those

extensioncordy

i cant find vise grips that are small enough to fit into the little hole around the shifter...i tryed plyer's, needle nose's, and vise grips....

extensioncordy

the thing that made me laugh the most...the old shifter...had no bearings or nothing on the bottem...they busted out or just plain rusted out...so right now im in a bad situation...i have no working shifter...