Down Pipe anyone?
10-08-2005, 04:49 AM
#1
Senior Member
Thread Starter
Join Date: Mar 2005
Posts: 186
Likes: 0
Received 0 Likes
on
0 Posts
Down Pipe anyone?
Custom built-- 3" square off the turbo, to a 3" bend...all the way out...backpresure? what's that?
Just picked up an LS block, and precision turbo kit on layaway...boost will be here before santa...no more gsr turbo, now a LS/vtec turbo...
Just picked up an LS block, and precision turbo kit on layaway...boost will be here before santa...no more gsr turbo, now a LS/vtec turbo...
10-09-2005, 11:29 AM
#2
Senior Member
Thread Starter
Join Date: Mar 2005
Posts: 186
Likes: 0
Received 0 Likes
on
0 Posts
BUMP--
I posted this to showcase the 3" square inlet to the 3" round because it alows for more air flow directly out of the turbo... 3" square is more volume than 3" round...
This downpipe configuration added about 60 whp for it's previous owner, as opposed to a 3" 90 degree elbow...
Checkout www.attituderacing.com for a performance / fabrication shop in Houston, TX
I posted this to showcase the 3" square inlet to the 3" round because it alows for more air flow directly out of the turbo... 3" square is more volume than 3" round...
This downpipe configuration added about 60 whp for it's previous owner, as opposed to a 3" 90 degree elbow...
Checkout www.attituderacing.com for a performance / fabrication shop in Houston, TX
