ctr n1 crank pulley
#1
been there done that
Thread Starter
ctr n1 crank pulley
anyone have any firsthand experience with one of these? good or bad?
my friend just bought one for his b20vtec project and was wondering what to expect from it.
my friend just bought one for his b20vtec project and was wondering what to expect from it.
#4
I've got the inlinefour single belt pulley, from back when CTR pulleys weren't available for a few months. As said, make sure you have the right belt or you'll end up with some annoying squeal in cold and wet.
What belt did you end up running Kai?
What belt did you end up running Kai?
#5
Originally Posted by Kai
HatchVX and I just put one on his car the other day.
Nothing much to say other then to make sure you have the right size belt for it.
Nothing much to say other then to make sure you have the right size belt for it.
#6
been there done that
Thread Starter
what im really concerned is with the stories of the pulley shortening the lifespan of the engine because it's not balanced and has no harmonics dampening. this is going onto a stock internals b20b block that will be rebuilt with new rings, gaskets, etc.
#7
Originally Posted by :snoopy:
what im really concerned is with the stories of the pulley shortening the lifespan of the engine because it's not balanced and has no harmonics dampening. this is going onto a stock internals b20b block that will be rebuilt with new rings, gaskets, etc.
If you're really worried about it you could get one of the IL4 pullies, they are an OEM pulley w/ rubber insert that's had the other two belts milled off.
Ding: http://www.inlinefour.com/infourn1encr.html
I wouldn't be too concerned about an OEM Honda part like the N1 pulley.
#9
Rotorphile.
Join Date: Mar 2002
Location: Richmond, VA
Posts: 10,120
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Qbacca
What belt did you end up running Kai?
Originally Posted by b16aEGcivic
what belt did you run?
#10
Originally Posted by Kai
I think it was a 230mm... HatchVX had to special order it from the Advance Auto down the street when we figured out the stocker didn't fit and our parts department didn't have anything small enough.
Hmm, I wonder if the diameter of the CTR pulley is the same as that IL4 pulley I got... I think I just ended up getting one size smaller than my stocker.