Lugnut Lock Help Needed!!!!!!!!!!!!
05-18-2005, 12:44 PM
#5
wtf goes here?
Join Date: Dec 2003
Location: Charlotte, NC
Posts: 5,782
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by DiAbLo3785
just go to any shop and have them monkey fu<k it out. worked for my dad and his truck
05-18-2005, 05:16 PM
#7
JDM GSR
Join Date: Feb 2005
Location: Cincy, Ohio
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
Or you could always take a fitting, size it up to the perfect size. After that take a hammer and slide it right over the locking lug. Might need a few of the same size fittings though 
. That's what I've always done to my locking lug nuts when the key breaks. I have bad luck with them, no matter how expensive the lugs are, they always break.
. That's what I've always done to my locking lug nuts when the key breaks. I have bad luck with them, no matter how expensive the lugs are, they always break.
05-19-2005, 12:52 PM
#9
Traction, WTF is that?
Join Date: Jan 2005
Location: College
Posts: 487
Likes: 0
Received 0 Likes
on
0 Posts
to brake it off would be kinda dumb. Go to some tire shops. They have to have some keys.
If not, if you can gain access to it easily, then take a SHARP chisle and a hammer, chisle a notch in the side and hit it to loosen it the same way you normally would. Thats the only way i got my bolts out that were stripped holding my rotors on.
If not, if you can gain access to it easily, then take a SHARP chisle and a hammer, chisle a notch in the side and hit it to loosen it the same way you normally would. Thats the only way i got my bolts out that were stripped holding my rotors on.