some kind of grind when i let clutch go
#1
some kind of grind when i let clutch go
i did a jdm b16a swap into my cx
the car started up the first time
i got hte motor from hmotors
i let hte car idle for 30min b4 start driving it
oil has been change motor and tranny
so after idling for 30min
i took it for a drive
so right when i get out of my garage i hear a major grinding sound
the sound only happens when i stop and go not when i change gears(if it does happen i dont notice it since u barely hold hte clutch in while changing gears)
it grinds right when the clutch catches then once the clutch is in all the way the sound goes away
i have mix comments on what it is
the input shaft bearing and throw out bearing
also if i shift alot it wont let me go into gear unless i turn off the car and put it into gear
its sometime hard to put into gear without any force
so what do you guys think it is
the car started up the first time
i got hte motor from hmotors
i let hte car idle for 30min b4 start driving it
oil has been change motor and tranny
so after idling for 30min
i took it for a drive
so right when i get out of my garage i hear a major grinding sound
the sound only happens when i stop and go not when i change gears(if it does happen i dont notice it since u barely hold hte clutch in while changing gears)
it grinds right when the clutch catches then once the clutch is in all the way the sound goes away
i have mix comments on what it is
the input shaft bearing and throw out bearing
also if i shift alot it wont let me go into gear unless i turn off the car and put it into gear
its sometime hard to put into gear without any force
so what do you guys think it is