Installing JDM Type R Cluster into 95 LS
11-11-2004, 09:44 PM
#1
Registered User
Thread Starter
Join Date: Oct 2003
Posts: 391
Likes: 0
Received 0 Likes
on
0 Posts
Installing JDM Type R Cluster into 95 LS
I want to buy the JDM Type R gauge cluster for my 95 LS. Does it matter if it came out of a 96 or 98 spec? Will all the wiring be the same. Like will it just be like swapping the a cluster. Thanks
11-12-2004, 08:00 AM
#3
Apathy Kills
Negative, Ghostrider.
Wiring changes will make this cluster swap [nearly] impossible.
Wiring changes will make this cluster swap [nearly] impossible.
__________________
:: :ToDspin: - supermod - but who gives a shit?
:: HAN Integra FAQ: If, by some miracle, yours hasn't been stolen... check it out!
:: HAN Integra FAQ: If, by some miracle, yours hasn't been stolen... check it out!
11-14-2004, 01:57 PM
#5
Senior Member
Join Date: Nov 2002
Posts: 276
Likes: 0
Received 0 Likes
on
0 Posts
you can always swap out the guages and carbon fiber outlay in the JDM unit, and put them in your stock unit.
I have just heard that the obd2 units will make wierd lights come on, and your fuel and temp needles will probobly start reading incorrectly.
but its not impossible, just a few more steps. good luck
I have just heard that the obd2 units will make wierd lights come on, and your fuel and temp needles will probobly start reading incorrectly.
but its not impossible, just a few more steps. good luck
11-15-2004, 09:55 AM
#6
I need sleep...
Join Date: Jun 2002
Location: NH
Posts: 3,632
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by 95tegRS
you can always swap out the guages and carbon fiber outlay in the JDM unit, and put them in your stock unit.
I have just heard that the obd2 units will make wierd lights come on, and your fuel and temp needles will probobly start reading incorrectly.
but its not impossible, just a few more steps. good luck
I have just heard that the obd2 units will make wierd lights come on, and your fuel and temp needles will probobly start reading incorrectly.
but its not impossible, just a few more steps. good luck
11-19-2004, 05:49 AM
#9
I need sleep...
Join Date: Jun 2002
Location: NH
Posts: 3,632
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by HaHAAHhAHHAH
got any pics of this?
01-20-2005, 04:56 PM
#10
Senior Member
Join Date: Nov 2002
Posts: 276
Likes: 0
Received 0 Likes
on
0 Posts
behind the cluster there are like screws holding the guages in place. one by one, unscrew them. I think its like 2 or 3 for each guage. You need a skinny long phillips. and then its just the matter of swapping the guages (and carbon fiber piece if you want) onto your old unit.