b18c1-88 accord LXI (need wireing harness)
#1
Never fast enough member
Thread Starter
Join Date: Nov 2002
Location: Arlington, TEXAS
Posts: 560
Likes: 0
Received 0 Likes
on
0 Posts
b18c1-88 accord LXI (need wireing harness)
Ok so I have all the parts needed to do the swap except for the wireing harness. My question is since it is an obd0 car can I use the same obd0-obd1 harness that they use in the CRX or OBD0 Civics. I know i will have to run a wire for the vtec to work, but besides that will there have to be any other wires run for this to work. I have heard of people useing a pr3(I think that is the code, it comes from a jdm b16a powered CRX) ecu in a crx and it did not require any kind of harness would this also work in the application I want it for?
Thanks for any help
Thanks for any help
#4
Never fast enough member
Thread Starter
Join Date: Nov 2002
Location: Arlington, TEXAS
Posts: 560
Likes: 0
Received 0 Likes
on
0 Posts
Yes I got the pri Axles, Shift Linkage, and motor mounts. I am going to use a cable tranny from a 92 integra and all I need now is the wireing. There are a couple of people with wireing harnesses on the 3geez site, but they want way to much money for those. I have been looking around and the pr3 ecu connectors looks almost Identical to the accord, but I have not seen them in person.