hoping for 300whp
#1
Registered User
Thread Starter
Join Date: Jul 2003
Location: Miami, Florida
Posts: 196
Likes: 0
Received 0 Likes
on
0 Posts
hoping for 300whp
wuz up all just got my engine built, will install soon, hopefully i can pull some decent power from it.
these are the extras i am installing to my existing set-up
sleeved block
pistons and rods
polished crank
port and polished cylinder head
stainless steel valves
new valve guides
titanium spring retainers
dual valve springs
stock cams
i also got my carbon fiber hood and truck, i might paint them so you see the carbon fiber slightly.
and my jdm one piece headlights
will post pics when i get a chance to take pics
these are the extras i am installing to my existing set-up
sleeved block
pistons and rods
polished crank
port and polished cylinder head
stainless steel valves
new valve guides
titanium spring retainers
dual valve springs
stock cams
i also got my carbon fiber hood and truck, i might paint them so you see the carbon fiber slightly.
and my jdm one piece headlights
will post pics when i get a chance to take pics
#4
Registered User
Thread Starter
Join Date: Jul 2003
Location: Miami, Florida
Posts: 196
Likes: 0
Received 0 Likes
on
0 Posts
they had regrind mine back to specs because it was out of specs.
AEBS built engine
AEBS sleeves
CP 88mm pistons, 9:1
Pauter rods
AEBS P&P head
Rev SS valves
Rev dual valve springs
Rev titanium retainers
stock cams
95 prelude se 2.3
AEBS built engine
AEBS sleeves
CP 88mm pistons, 9:1
Pauter rods
AEBS P&P head
Rev SS valves
Rev dual valve springs
Rev titanium retainers
stock cams
95 prelude se 2.3