jdm or usdm ? howto tell which
07-04-2004, 12:05 AM
#1
Registered User
Thread Starter
Join Date: Feb 2004
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
jdm or usdm ? howto tell which
I have a integra LS block and i was wondering if there is any way to tell if it's a JDM block or USDM block?
also, which ways are the best to tell if it is truly a 30k block...
thanks
also, which ways are the best to tell if it is truly a 30k block...
thanks
07-05-2004, 06:31 PM
#6
Rotorphile.
Join Date: Mar 2002
Location: Richmond, VA
Posts: 10,120
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by BassmintPimpin
Yea, I dont think JDM cars came without VTEC.
Originally Posted by RicoD
JDM integras i believe were all vtec...
07-05-2004, 06:34 PM
#7
I hate 2003 Noobs.
Join Date: Aug 2002
Location: tx
Posts: 5,112
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Snoopy
there was no jdm b18a/b
There was a jdm b18b and it had a compression ratio of 9.4:1.
h: I believe the blocks are the same so it doesnt matter if its jdm or not.
07-05-2004, 06:39 PM
#8
Rotorphile.
Join Date: Mar 2002
Location: Richmond, VA
Posts: 10,120
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by txhatch
There was a jdm b18b and it had a compression ratio of 9.4:1. h:
h:Unless it came out of some funky Japan only car.