Replacing Clutch Master and Slave Cylinders
#1
Dumped4life
Thread Starter
Join Date: Apr 2004
Location: Omaha, NE
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Replacing Clutch Master and Slave Cylinders
Do I need a flare wrench to get the fluid lines off. And is there anything else special that I would need?
Oh if I do need a flare wrench can you please give me the size that it needs to be (?mm)
I have a 1994 Accord EX btw.
Oh if I do need a flare wrench can you please give me the size that it needs to be (?mm)
I have a 1994 Accord EX btw.
#2
Try an open-end wrench & see. That'll tell you the size, and if you try without pulling too hard, you can see if you can loosen the fittings.
With an open-end wrench it's easy to round off the corners of the fittings. That doesn't always happen, but when it does you'll wish you had gotten a flare wrench. The risk is if the fitting is tight you'll pull hard enough to round it.
With an open-end wrench it's easy to round off the corners of the fittings. That doesn't always happen, but when it does you'll wish you had gotten a flare wrench. The risk is if the fitting is tight you'll pull hard enough to round it.
Thread
Thread Starter
Forum
Replies
Last Post
AwwsChwA
Engine Swaps, Tech & Tuning
3
04-15-2003 11:17 AM