Diy - Valve Adjustment Tool

[dwnthehatch]

I was about to buy a Snap On jam nut tool for $60 when I came across a thread on H-T that had instructions on how to build one. You will need the following: 10mm 3/8 drive deep wall socket 5/8" wrench flat head screwdriver All you have to do is hammer the 10mm socket into the 5/8" wrench and stick you screwdriver in the hole of the socket. If you want the tool to be 1 piece, find a flat head screwdriver that has a tip wider than the hole in the 10mm socket and hammer it in. I had to grind a little bit off of the side of the screwdriver to make mine fit. Here's the end result: Thanks to UncleBen'sRacing for the instructions.

Registered and logged-in users don't see this ad! Register your free account today.

[jackasssi]

Sorry but that's ghetto as hell. You could buy a cheap flat blade screwriver with a 10mm nut under the handle. . . .but whatever works.

[qualude]

Please contact me at: joe.stanczak@indymacbank.com if you are interested