AcuraIntegraLS

K20A
Vin: S604177
I purchased this motor in summer 06 for $5,500 and spent another $6,410 building it in summer of 07. Work was done at Westchester Crankshaft by Spanky.
Buyer will provided with receipts.
Motor was street & Dyno tuned by Chameleon.
My loss is your gain!

Motor:
Port+Polish
3 Angle valve job
Ferrera vlaves
Rebore & Hone: 86mm
Balanced
Crower stage 2 cams
JE Pistons
K24 oil pan
RBC intake manifold w/ BDL 70MM
Golden Eagle Fuel Rail (Red)
half shaft
92-95 Headers
Header gasket *New*
KoyoRad w/ Mishimoto slim fan
Heatshield gasket *New*
*A/C & P/S was deleted*
Aeromotive Fuel Pressure regulator w/ guage
ARP headstuds
Type R spark plug cover
AEM intake manifold w/out filter

Harness is ready to plug n play into 92-95 chassis (harness was done by Chameleon)

Type R Tranny (LSD - 6Speed) w/ Exedy stage 2 clutch (2nd Gear was replaced by chameleon)
Shifter w/ cables

The Bad:
You will need Kpro (*Recommended since motor is built)
Axles
Injectors w/ Clips (*I used RC 550c)
TPS sensor

I'm located in Bronx, NY. Motor will need to be picked up (*I can try to ship it but buyer is responsible for shipping*). It's corrently in a storage and can be seen on the weekends unless your serious then ill take a day off work. Also note I've removed waterpump, alternator, starter because I was going to clean motor up but my EK was stolen so I don't feel like doing it anymore.

I'm asking $6,800 o.b.o. I need this motor gone ASAP!!! NO TRADES!!! Not parting out either !!! Money talks PM or Text/Call Nelson @ 646-369-5935.

I'm willing to work with SERIOUS buyers!