GSR Integra. High RPM when clutch pushed in
I just fixed a problem with the integra GSR. The vehicle speed sensor was replaced.
Now when I am slowing down to stop at a light, I was going about 30km/h, and push the clutch all the way in and the rpm will stay at 3000rpm till about 20 seconds after I have stopped. (engine already warm)
Was wondering what I should look for?
I'm not anywhere near what I'd call knowledgable... but i'm going to pretend I am for a second, and suggest maybe a reset of the ecu could help?? Just a guess, maybe someone else can back my thought up, or correct it by telling me i'm an idiot. :P
'96 Red GSR: Skunk2 SS, ACT HDSS, Fidanza 7.5lb Flywheel.
'05 Black WRX STi: Stage2 (Engine Management & Exhaust)
Lexus Tech y0!!
you can probebly check your thermostat. either that or your IACV(idler air control valve) and see if its dirty and you can clean it up. check your cap and rotor, plugs and wires. those are just suggestions on what to check that could be contributing to this problem.
09 Civic EX - current DD
03 VW Jetta Wolfsburg Edition 1.8T APR tuned - totalled
94 Integra LS - sold
94 Civic Ferio - stolen/raped
Honda and the Honda marquee are registered trademarks of the American Honda Motor Company, Inc. Neither American Honda Motor Company nor its subsidiaries or affiliates shall bear any responsibility for Honda-acura.net content, comments, or advertising. Honda-acura.net is not affiliated with American Honda Motor Company in any way. American Honda Motor Company does not sponsor, support, or endorse Honda-acura.net in any way. Copyright/trademark/sales mark infringements are not intended or implied.
Search Engine Friendly URLs by vBSEO