is water supposed to be here b18b1
#1
Junior Member
Thread Starter
Join Date: Mar 2010
Location: honda land
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
is water supposed to be here b18b1
was replacing head gasket and seen this is water supposed to be here around the piston cylinder there was water on a few pistons as well and do i need to remove this water thanks in advance
#2
Apathy Kills
Don't remove the coolant around the cylinder bores. The cylinder bores are free-standing on B-series; also known as "open deck." The head gasket and the head provides the seal between the bores and the block.
It would be wise to siphon the coolant off the pistons, however.
Related question... is the engine consuming coolant?
It would be wise to siphon the coolant off the pistons, however.
Related question... is the engine consuming coolant?
__________________
:: :ToDspin: - supermod - but who gives a shit?
:: HAN Integra FAQ: If, by some miracle, yours hasn't been stolen... check it out!
:: HAN Integra FAQ: If, by some miracle, yours hasn't been stolen... check it out!
#3
trm4life
Join Date: Oct 2012
Location: Iowa City, Iowa
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
Well, if you remove the plug on the front of the engine, the coolant will drain. You should put fresh coolant in after you do the gasket anyway, because you will get debris in the coolant.