Dropped the motor in today. I knew the wiring was going to be on the oposite side of the engine bay but after looking at all of it (and really trying to keep a clean lookin engine bay) i've decided that i really dont want any part in splicing all that shit. I pretty sure there is a harness out there for my swap. Im looking for who makes it and where i can get it.

thanks for youR help guys

 

JDM engine I'm guessing? You should be able to re-use your existing harness off your D16Z6 that you just pulled. Would have been a lot easier to change with the motor out though. You will have to add the knock sensor wire (just pull the one out of the JDM harness and re-use it). I think that's the only change, but I'm not sure for a Del Sol.

 

See the problem is that I pulled my motor back last may. In the process of trailering and moving the car around for close to a year I lost that harness. I did find this however

http://www.hasport.com/store/index.html

I was looking at the GSR subharness. Would that take care of it?