Corner Alignment?

[The G2 Racer]

The amber corners on my ride don't really sit right. The bottom appears to be angeled upwards and it should be flush with the bumper (flat). How can I fix this. It bothers me because my front end looks goofy.

[HLD_Civic]

can't really be fixed. It's how they're made. They're made out of cheap plastic. I've had about 4 different pairs of clear corners and they're all off a little.

[The G2 Racer]

But these are horrible. I've got to get them to sit a little better.

[SeeCamGo]

If they are in all of the way then there isnt much you can do.

What brand/kind are they?

[The G2 Racer]

vision knock offs paint amber by me.

[asiandoood]

What were they originally? Anything not OEM will not fit like OEM.

[The G2 Racer]

Vision clears. Not sure on the company that makes them. They have Vision writen on them. Got them from the local ricer shop when I first got the car. My guess is Ractive or something? Not sure.

[asiandoood]

The authentic Visions will have the "Vision Technica" logo and will look and feel like OEM with half black and half beige housing in the back. The plastic is also of a higher quality like OEM with heavier weight. They would be packaged in Vision stamped logo in red all over a white box.


Fake Visions will have the "Vision Technica" logo on it...with either all chrome, all biege or all black housing. The plastic is of lighter weight and will feel like all the other clear, euro, blah blah APC type corners out there. These will be packaged on a plain white box with a warning sticker.

[smudge]

Is this what the box should look like?It has a vision headoffice address on it,but the backs are 1/2 crome and 1/2 black.


I think they are fake,but i got a REALLY good deal.

[asiandoood]

they knocked off the box too?

[The G2 Racer]

These just came in a white box. But where not amber, they where clear. I painted them amber cause I felt that the clear looks goofy. I also painted the houisng flat black.

Back to the orginal question any way to get them to sit better?

[Cashis EG8]

I think that's just how it is going to sit. I went back to OEM corners because nothing else fit as well.

[asiandoood]

Originally posted by Cashis EG8
I think that's just how it is going to sit. I went back to OEM corners because nothing else fit as well.

the cheaper plastic corners with the glass light housings dont really match either... but the amber should cover that up

[smudge]

I fixed one today.The screw hole was wrong so i slotted it abit.Hold it in place and check to see if the screw holes are 100% lined up.
I hope this helps.