Conecting Rods??
#1
Senior Member
Thread Starter
Join Date: Oct 2002
Location: connecticut
Posts: 278
Likes: 0
Received 0 Likes
on
0 Posts
Conecting Rods??
I am looking to build up the bottom of my engine,what would be the best rod desgin. a x beam rod h beam rod or i beam rod? i will be putting a supercharger or a turbo on the car eventually. i am gonna be useing a steel crank.
#2
のんびり~(´ε`)
You can't beat ESP(Eagle Specialty Products) rods for the price. They're around $330-350/set, forged H-beam, and are very durable. They're good for up to 600-700hp. Make sure you get some ARP rod bolts as well.
#3
Still here... sorta...
I have Eagle H rods in my B18C1 swap. I went with them because Crower just seemed like overkill and they're pretty darned expensive. I got my rods off of www.groupbuycenter.com from www.importparts.com for a really good price.
They have ARP bolts and they're super nice! What motor are you building?
They have ARP bolts and they're super nice! What motor are you building?
#6
のんびり~(´ε`)
Originally posted by ManTiS
Eagle rods + JE pistons ... how un-original
Eagle rods + JE pistons ... how un-original
They're cheaper than JE's, too
#7
Still here... sorta...
I went with SRP (made by JE)
Total Seal Rings...
https://www.honda-acura.net/forums/s...threadid=20309
Setup is listed near the bottom.
Total Seal Rings...
https://www.honda-acura.net/forums/s...threadid=20309
Setup is listed near the bottom.