Once they are completely dry you can remove the tape from the masked areas and begin the install process.
The install is relatively simple but besure that you properly allign the arms when attatching them back on the posts. In this step I also used a bit of white lithium grease on the posts and sockets to prevent any furthur corrosion. To allign the posts I only half tightned them and turned the wipers on untill they stopped at their highest and lowest point checking for cleance. Once alligned you can tighten the bolts all the way. Now you can put the hood down, take a step back, drink a beer, rip a fart and smile at a job well done. This DIY took about 3 hours due to the extended drying time needed in my case but could easily be completed in under 2 hours. Here they are installed... ENJOY!
If anyone has suggestions or questions please feel free to ask.